The CA Tuned Full Suspension Hardware Kit is your all-in-one fastener solution for fully rebuilding or upgrading your BMW E30 suspension system. This comprehensive kit eliminates the guesswork by providing the exact bolts, nuts, and washers needed for a clean and complete install.
- Fits all BMW E30 chassis (1982–1993)
- Includes high-grade hardware for front and rear suspension components
- Perfect for restorations, coilover installs, or bushing upgrades
- All fasteners are zinc-coated for corrosion resistance
- Organized and labeled for ease of installation
Whether you're performing a full suspension refresh or prepping your E30 for the track, this CA Tuned hardware kit ensures long-term reliability and a professional fit.
Mounting kit for the chassis of the BMW 3 series, E30,
suitable for the models with M10, M20, M40, M42, S14 engine and the 168+ 188 differential
The set consists of screws, nuts, and washers for the following parts:
- 4x axle swings rear axle 10.9
- 4x mounting differential 10.9
- 4x holding block of the handbrake (only for rear disc brake)
- 10x anchor plates
- 4x tie rods (the plates under the barrel bearings)
- 2x special nuts of the barrel bearings
- 2x shock absorber rear
- 4x rod holder
- 4x nut of the rod holder
- 4x stabilizing pocket
- 4x front axle carriers (also for axle lowering on request)
- 2x steering gear
- 4x wishbone bearing
Total 104 parts
Rear shock absorber hardware built from strength of a class 8.8 just low the OE Hardware found from BMW.